GPO Double Australia free 3D model

Preview of the double GPO in Australia

This is a typical double GPO in Australia i.e. Australian plug systems, standard AS/NZS 3112 (Type I). It's also the same as the ones used in New Zealand, and similar to those used in China. I had one in my house and decided to measure and model it. No textures required.

GPOs in Australia are usually set at 450mm to their horizontal centerline above the finished floor level. An exception occurs in some places such as disabled bathrooms where they are set at 600mm in order to make it easier for disabled access.


The colours have been calibrated with Macbethcal but the specularity and roughness values are guessed.


This Radiance model follows the Radiance Filesystem Hierarchy Standard. As such, please run make lib to build the Radiance mesh file. Once done, you can use this in your scene by:

!xform lib/gpo-double-australia/obj/model.rad


This model was created by Dion Moult.

Free 3D model download


If you have any comments, please send them to